Help Fitting Tickford Suspension Kit (AU3)

[fourl6]

so fitted the back ones today sitting maybe a 2cms lower but will settle down i think... had a knocking in the back right so tightened up the bolt on the top an bottom of the shocker and that fixed it up...

just after some advise with the front ones... oh and in the suspension kit i got one bracket with a rubber bit on the end.. anyone know where this goes... had a look around when i didnt see anything... its about 10x10x10cms with two holes to be bolted onto something...

just after some instructions like this (found in another thread) but for the front would be good..

changing rear shocks would have to be one of the easiest jobs u can do

jack up car and remove rear wheels and place stands under rear axles

lay down rear seat and remove plastic corner covers to gain access to top of shocker

remove top shocker nut - hold top of shocker shaft with a small shifter or mole grips and undo nut

undo bottom shocker bolt and remove

lower the shocker out thru the spring


installation is reversal of above - with note - make sure bottom bolt is very tight else you will have a knocking niose that will drive you nuts and it is not a bad idea to retension in a couple of weeks time with the full weight of the car on it.

cheers..