AU 2 Elec Mirror Switch

[Fairlane]

Does anyone know how these switches work, i was fiddling around with the RHF door trim today and i couldnt get the mirror wiring to disconnect, it just wouldnt budge when i tried to release it with a screwdriver.

Anyhow the trim was accidently knocked over and the switch/toggle base disconnected from the shaft and knob, etc (Exploded is probably a better word) and it flew into its component parts and scattered ever which way :gren: . Now does anyone know how it goes back together, or should i just buy a new switch in one piece at the wreckers.

The parts i have is the

1* Switch Knob
1* Knob Shaft - with cross shaft at bottom
1* Knob Housing the one in the Door Trim (couldnt lose that)
1* Knob Housing - White Plastic one in which the shaft sits into from underneath

2* Springs (I think they belong to it)- About 2cm long- Rolled at one end and curved a bit at the other

And of Course the main Switch with toggle/cicuit board thingie (mmm Very Technical) and the switch wiring loom at the back.

** I know its a long shot but does anyone know how it goes back together or if i atleast have the requied parts.