power window hook up for the rear

[low au classic]

hey i just wanted to know if anyone has hooked up power windows in the rear
i have found this http://cgi.ebay.com.au/Ford-AU-BA-re...1%7C240%3A1318
is there anything else i need to do or will there already be a wire ther for it or not?
if any one else has done this before some instructions would be great thanks

[fourl6]

cars with rear power windows have a different h loam and i think an extra wire out the bem? but shouldnt be to hard to get it to work with some speaker wire... hooking it up to the front switch is the hard part

[MaTTe]

as cam said, it has a different interior loom on both sides (they join in the middle)
You'll need the window mech for both rear doors like in the ebay link, you'll need the interior door skins with the power window buttons rather than the winders, you'll need the drivers door switch with 4 buttons, you'll need the door looms for the rear doors and the drivers door (so it works with all 4 doors) and then the bem will either need replacing or reflashing, i'm not sure which.

you probably can wire most of it up with speaker wire, but it'll be alot more involved.

good luck

[Ronza]

hmmm i plan on doing same conversion on my AU i have AU3 XR interior to fit all electrics and all regs and loom to the rear but its a bit scary hearing how much work it will take!!! still an excuse to give it a go LOL!!!

[fourl6]

hey ronza... im speaker wiring it because i dont care if my 4 way switch works the back... i just want my rear door trims in... (have some ba trims) so i think i just need to run a power into the rear doors... which i have a pin from the front that has 12v on/off with the rear window lock button... but i think you should be right if you get the h loam+drivers... ftg quoted me $250 for rear regs, au h loom and ba rear door looms...