Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > Club and Speciality Forums > Forum Community Car Clubs > OzECruisers (E/N/D Series) > OzECruisers General Discussions

OzECruisers General Discussions E/N/D vehicles General Discussion ONLY. NO TECH THREADS

Reply
 
Thread Tools Display Modes
Old 08-10-2006, 11:35 PM   #31
Joes_meat
Churches Eat Souls
 
Join Date: Feb 2006
Posts: 202
Default

VS Commodore
$5000 purchase.
$10 thermostat.

EF Falcon
$2950 purchase.
$63 O2 sensor.
$60 leads.
$40 two sets of spark plugs.
$40 - Machined front rotors and new pads all around. (Yes $40 )
$60 10x 5 litre bottles of coolant.
$11 Radiator cap (hopefully fixes previous problem.)
Rear transmission seal - Pending.
Joes_meat is offline   Reply With Quote Multi-Quote with this Post
Old 09-10-2006, 11:48 AM   #32
Interceptor'85
Interceptin'
 
Interceptor'85's Avatar
 
Join Date: Jan 2005
Location: Melbourne
Posts: 970
Default

A bit over $600 on new headlights, new coolant tank, new custom 3" EL intake, and shims for cam shaft that im yet to buy. All genuine ford parts too ;) yummy!
__________________
'95 EF II Falcon,
'INTERCEPTOR'
'72 XA Fairmont Coupe,
'XA Muscle'

Interceptor'85 is offline   Reply With Quote Multi-Quote with this Post
Old 09-10-2006, 05:02 PM   #33
white_XR8
Regular Member
 
Join Date: Aug 2006
Posts: 66
Default

Bought mine for $9,400 Spent
$1000 on herrods Exhuast,
$2.1 on rims with Hankook silica tyres low profile,
$600 on front respray, side skirts, mirrors, back.
$300 on sequential scoop, air intake comming soon!
All new brake pads, front disks changed.
$350 Lowered on super low kings springs
$450 welsh plugs replaced
$150 on premium service
$150 for new xr interior mats
$350 Headunit
$150 Hotdog
And thats only a start
Comming soon!
- Extractors
- Fine tune
- sub, speakers, amp etc
- Air intake
- Ba bonnet buldge
- Few things to do to engine would eventually want it running around the 200+ KW.
:SaiyanSmi

Any other sugestions would be great thanks
white_XR8 is offline   Reply With Quote Multi-Quote with this Post
Old 09-10-2006, 05:08 PM   #34
castek
FF.Com.Au Hardcore
 
Join Date: May 2006
Posts: 514
Default

$299 for a ex-demo pioneer spl sub. virtually brand new.
$350 for a kenwood 1800w mono block brand new from the states
$350 all new rear end, incl. bushes, arms, diff (reco) brakes etc.
castek is offline   Reply With Quote Multi-Quote with this Post
Old 09-10-2006, 05:43 PM   #35
GREERZ_04_BA
Dude.Sweet.Dude.Sweet
 
GREERZ_04_BA's Avatar
 
Join Date: Aug 2005
Location: bayswater north
Posts: 341
Default

$1400
$1200 on a EF engine
and $200 on a raidator.
__________________
:eclipsee_ GREERZ
2004 BA XR8
full leather,premo sound,sat nav.

.


www.myspace.com/greerz86
GREERZ_04_BA is offline   Reply With Quote Multi-Quote with this Post
Old 09-10-2006, 10:56 PM   #36
Bill_R
FF.Com.Au Hardcore
 
Bill_R's Avatar
 
Join Date: Aug 2006
Posts: 1,335
Default

Quote:
Originally Posted by kyro_02


i have to do the follow in a month cause its getting bad!!

.... wheel alignment(bad vibrations at 60kmph+ when turning right, turning left is ok though)
I don't think an alignment is going to fix that somehow. It sounds like "something" is gone and needs replacing. If it was shudder that starts at a specific speed it might be as simple as a balance but the fact you get it when turning one way indicates a repair might be needed.
Bill_R is offline   Reply With Quote Multi-Quote with this Post
Old 09-10-2006, 11:33 PM   #37
Obriza
Banned
 
Obriza's Avatar
 
Join Date: Aug 2005
Location: Melbourne
Posts: 607
Default

Ive spent shitloads on mine...
just this year
rims $2000
custom intake $388
a few repairs comes up to about $1000
tint $265
tuning/chip $1200
lowering $200 (very cheap)

That adds up to about $5000
Obriza is offline   Reply With Quote Multi-Quote with this Post
Old 09-10-2006, 11:54 PM   #38
Lumpen Proletariat
Regular Member
 
Join Date: Feb 2005
Posts: 372
Default

Had it for about 7 months and done about 5,000km.


In that time:

Done:
Ferodo Pads all round
New (manual) Pedal Box
Full Service (including new sump plug, bled brakes etc)
Wheel Alignment and Balance
Altenator Rebuild
Wiper Blades
Rego/CTP/Transfer Fee/Stamp Duty/Late Fee


Bought and To be Fitted ASAP:
Autogauge 2" Water Gauge
MSD Coil, Cap, Rotor and Leads
Autolite Platinum Plugs
New Front 225/50/16's


Imminent:
Set of Engine Mounts
Gearbox 'flushed and filled' with Transmax Z
Diff 'flushed and filled' with LS90.
UnMelted EGR


Due for Replacement:
Oxy Sensors
Fuel Pump
MAF
Chiptorque (2nd Hand, Custom Programming)


Spent around $2300 on top of Purchase Price (including rego) with only a few hundred to go before I'm happy with the maintainence and safety side of the thing, then I can add some doo-dads etc and so on.


Lumpy
__________________
Me: 1991 EBI XR8: Pearl Black. Manual. Full Exhaust. 16" CSA Edge. Trip Computer.

Dad: 1994 ED XR8 Sprint: Polynesian Green. Auto. Full Exhaust. Chiptorque Chip. 155.4rwkw.

Happy Dealings with: FordFan86 and Matt_971

Last edited by Lumpen Proletariat; 10-10-2006 at 12:25 AM.
Lumpen Proletariat is offline   Reply With Quote Multi-Quote with this Post
Old 10-10-2006, 06:02 PM   #39
LowEL2XR8
Mr Impulsive
 
LowEL2XR8's Avatar
 
Join Date: Feb 2005
Location: Perth NOR.
Posts: 1,309
Default

Quote:
Originally Posted by *rayman*
LowEFGLi - How did you manage to spend $1000 on pulleys and throttle body? A tad expensive yeah?
Not really. That was for under drives plus labour, throttle body and egr spacer plus labour.
Throttle body is not just a straight swap over thanks to the Americans having their engine the wrong way round
__________________
Owned Fords
85 Telstar (man), 96 EF GLi (auto), 95 EF XR6 (man), 97 EL Fairmont Ghia (auto), 98 EL XR8 (man), 06 BF wagon (auto), 06 BF XR6 (ZF auto), 08 FG G6E (ZF auto), '10 SY MKII TS Territory (4spd)
LowEL2XR8 is offline   Reply With Quote Multi-Quote with this Post
Old 11-10-2006, 01:07 AM   #40
penrith_panther
EB II
 
penrith_panther's Avatar
 
Join Date: Oct 2006
Posts: 676
Default

Quote:
Originally Posted by white_XR8
Bought mine for $9,400 Spent
$1000 on herrods Exhuast,
$2.1 on rims with Hankook silica tyres low profile,
$600 on front respray, side skirts, mirrors, back.
$300 on sequential scoop, air intake comming soon!
All new brake pads, front disks changed.
$350 Lowered on super low kings springs
$450 welsh plugs replaced
$150 on premium service
$150 for new xr interior mats
$350 Headunit
$150 Hotdog
And thats only a start
Comming soon!
- Extractors
- Fine tune
- sub, speakers, amp etc
- Air intake
- Ba bonnet buldge
- Few things to do to engine would eventually want it running around the 200+ KW.
:SaiyanSmi

Any other sugestions would be great thanks
damn where's your premium service @? thomson ford charged me 680 :(
penrith_panther is offline   Reply With Quote Multi-Quote with this Post
Reply


Forum Jump


All times are GMT +11. The time now is 09:18 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL